Skip to content

HSI-88 interface configuration

This page describes how to configure an HSI-88 feedback interface in Traintastic.

Supported connection types

The HSI-88 can only be connected to Traintastic using a direct serial cable connection, or using a USB-to-Serial adapter.

Connection settings

  • Device – Path to the serial device (e.g., COM3 on Windows or /dev/ttyUSB0 on Linux).

HSI-88 settings

Feedback modules

  • Modules left – Number of 16-port S88 feedback modules connected to the left connector.
  • Modules middle – Number of 16-port S88 feedback modules connected to the middle connector.
  • Modules right – Number of 16-port S88 feedback modules connected to the right connector.

Debugging

  • Debug log RX/TX – Log all HSI-88 communication (hex) for debugging purposes.

Need help or having issues?

If you encounter problems while configuring the HSI-88, or if your setup behaves differently than expected, check the community forum. Sharing your configuration and findings helps others and improves Traintastic.