Skip to content

Interface configuration

Traintastic supports a wide range of digital command stations, feedback sensors, and wireless throttle devices. This section provides detailed instructions on configuring each supported interface for advanced users who need more control or whose setup is not fully covered by the setup wizard.

For a complete list of tested and supported hardware, see the Supported hardware page.

Overview

The interfaces covered in this section include:

Command Station interfaces

These allow Traintastic to communicate with the layout's digital system and control locomotives, turnouts, signal and read feedback sensors:

Wireless throttle interfaces

Connect wireless hardware throttles to Traintastic for real-time train control:

Feedback sensor interfaces

Enable detection of train positions and layout events:

Custom / DIY Interfaces

For users building their own hardware:

Using the Setup Wizard

Whenever possible, use the setup wizard to add and configure interfaces. The wizard guides you through a step by step setup and applies recommended settings. This is the preferred method for most users.

Manual Configuration

Some interfaces, custom setups, or advanced features may require manual configuration. Each page in this section provides step-by-step instructions, including:

  • Interface requirements and limitations
  • Connection and setup procedures
  • Recommended settings and troubleshooting tips

Community Support

If your interface or device is not listed, or if you encounter issues during configuration, check the community forum. Sharing your experience helps improve Traintastic and expands the supported hardware documentation.