Skip to content

Digikeijs DR5033

The Digikeijs DR5033 is a smart LocoNet booster with basic diagnostic feedback and remote control support.

Supported diagnostics

  • Load
  • Temperature (reported but not functional)

Control capabilities

  • Power district can be enabled/disabled using an accessory address

Requirements and notes

  • The temperature value always reports zero, even though the booster exposes this field
  • The load value remains zero until the track current reaches approximately 400–500 mA
  • Status feedback is limited compared to newer smart boosters

Configuration

  • Interface – The LocoNet interface used to communicate with the booster
  • Address – Booster LNCV address (factory default: 1)
  • Polling interval – Interval (in seconds) at which diagnostic data is requested (default: 5 seconds)

Warning

Using a very short polling interval increases traffic on the LocoNet bus and may negatively affect overall system performance. The default value is recommended unless faster updates are really needed.