Skip to content

Uhlenbrock Power 4/7/22/40/70

The Uhlenbrock Power series are smart LocoNet boosters that provide basic diagnostic feedback and remote control support.

Supported diagnostics

  • Load
  • Temperature

Control capabilities

  • Power district can be enabled/disabled using an accessory address

Requirements and notes

  • These boosters have not yet been fully verified with Traintastic. Based on protocol compatibility and documentation, they are expected to work.

Configuration

  • Interface – The LocoNet interface used to communicate with the booster
  • Address – Booster LNCV address (factory default: 1)
  • Polling interval – Interval (in seconds) at which diagnostic data is requested (default: 5 seconds)

Warning

Using a very short polling interval increases traffic on the LocoNet bus and may negatively affect overall system performance. The default value is recommended unless faster updates are required.